Default Nde Configuration; Nde Configuration Guidelines And Restrictions; Configuring Nde - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Default NDE Configuration

Default NDE Configuration
Table 46-4
Table 46-6
Feature
NDE
NDE of ingress bridged IP traffic
NDE source addresses
NDE data collector address and UDP port
NDE filters
Populating additional NDE fields

NDE Configuration Guidelines and Restrictions

When configuring NDE, follow these guidelines and restrictions:
•
•
•
•

Configuring NDE

These sections describe how to configure NDE:
•
•
•
•
•
•
Note •
•
•
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
46-10
shows the default NDE configuration.
Default NDE Configuration
NDE supports IP multicast traffic only with
NetFlow aggregation must use NDE version 8 or version 9.
NDE supports bridged IP traffic.
NDE does not support Internetwork Packet Exchange (IPX) traffic or any other non-IP protocol.
Configuring NDE on the PFC3B, page 46-11
Configuring NDE on the PISA, page 46-13
Enabling NDE for Ingress-Bridged IP Traffic, page 46-14
Displaying the NDE Address and Port Configuration, page 46-15
Configuring NDE Flow Filters, page 46-16
Displaying the NDE Configuration, page 46-18
You must enable NetFlow on the PISA Layer 3 interfaces to support NDE on the PFC3B and NDE
on the PISA.
You must enable NDE on the PISA to support NDE on the PFC3B.
When you configure NAT and NDE on an interface, the PFC3B sends all fragmented packets to the
PISA to be processed in software. (CSCdz51590)
Default Value
Disabled
Disabled
None
None
None
Enabled
NetFlow version 9.
Chapter 46 Configuring NDE
OL-11439-03