Protecting Access To Privileged Exec Commands; Setting Or Changing A Static Enable Password - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Protecting Access to Privileged EXEC Commands

#
#
#
#
#
#
<information deleted>
#
#########################################################################
# Start of individual host entries
#########################################################################
Router:
dross:
<information deleted>
Protecting Access to Privileged EXEC Commands
The following tasks provide a way to control access to the system configuration file and privileged
EXEC commands:
•
•
•
•
•
•

Setting or Changing a Static Enable Password

To set or change a static password that controls access to the privileged EXEC mode, perform this task:
Command
Router(config)# enable password password
This example shows how to configure an enable password as "lab" at the privileged EXEC mode:
Router# configure terminal
Router(config)# enable password lab
Router(config)#
To display the password or access level configuration, see the
and Privilege Level Configuration" section on page
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
3-14
rl -- resource location protocol servers
sm -- subnet mask
tc -- template host (points to similar host entry)
to -- time offset (seconds)
ts -- time servers
tc=netcisco0:
tc=netcisco0:
Setting or Changing a Static Enable Password, page 3-14
Using the enable password and enable secret Commands, page 3-15
Setting or Changing a Line Password, page 3-15
Setting TACACS+ Password Protection for Privileged EXEC Mode, page 3-16
Encrypting Passwords, page 3-16
Configuring Multiple Privilege Levels, page 3-17
Chapter 3
ha=0000.0ca7.ce00:
ha=00000c000139:
Purpose
Sets a new password or changes an existing password for the
privileged EXEC mode.
"Displaying the Password, Access Level,
3-18.
Configuring the Switch for the First Time
ip=172.31.7.97:
ip=172.31.7.26:
OL-11439-03