Removing The Front Subchassis And Rear Electronics Bay; Installing The Front Subchassis And Rear Electronics Bay - Intel SPSH4 - Server Platform - 0 MB RAM Product Manual

Removing the Front Subchassis and Rear Electronics Bay

To remove the front subchassis:
1. Disconnect all cables attached to the power distribution board and to the baseboard.
2. With the front subchassis open, lift it straight up and clear of the main chassis.
To remove the electronics bay:
With the electronics bay open, pull it up and toward the front of the chassis, lifting it clear.

Installing the Front Subchassis and Rear Electronics Bay

To install the front subchassis:
1. With the front subchassis tilted open about 30°, align the notch in the subchassis with the hinge
pins on the main chassis (Figure 37).
2. Lower the subchassis straight down until the hinge pins engage the notches.
3. Connect all cables from the front subchassis to the power distribution board and to the
baseboard.
To install the electronics bay:
1. With the electronics bay tilted open about 30°, align the pins on the electronics bay with the
notches in the main chassis (Figure 37).
2. Lower the electronics bay until the pins engage the notches and slide it back and down.
Figure 37. Installing the Front Subchassis and Rear Electronics Bay
104
OM13403
Intel SPSH4 Server Platform Product Guide