Front Control Panel; Spsh4 Front Control Panel; Front Control Panel Features - Intel SPSH4 - Server Platform - 0 MB RAM Product Manual

Front Control Panel

Figure 55 and Table 11 describe the features of the front control panel of the SPSH4 server
platform.
Table 11. Front Control Panel Features
Device
A Power button
B Sleep button
C Reset button
D Chassis ID button
E NMI switch
F USB connector
G Serial port connector
H Lock
I Chassis ID LED
J LAN2 LED
K LAN1 LED
L Hard drive activity LED
M Fault LED
N Main power LED
Server Description
N M L K J I
A B C D E
Figure 55. SPSH4 Front Control Panel
Operation
To turn power on, press the power button momentarily. If the system is in
sleep state, pressing the power button momentarily brings the system out of
the sleep state.
To turn power off, press and hold the power button for more than four
seconds. This overrides ACPI mode.
To put a system supporting ACPI into sleep mode (S1), press the sleep
button momentarily.
To wake a system from sleep mode, press the sleep button momentarily.
To reset the system, press the reset button momentarily.
To clear CMOS, press and hold the reset button for at least four seconds,
and then press the power button. Release both the reset and power buttons
at the same time. The system will power on and the CMOS will be reset.
Illuminates LEDs on both the front and rear of the chassis, simplifying
identification of the chassis in a rack from the rear.
Causes a non-maskable interrupt. Located behind the bezel door.
USB port 3. Located behind the bezel door.
Serial port B. Located behind the bezel door.
Locks the bezel and front access cover.
Blue indicates chassis ID is active.
Green indicates LAN2 activity.
Green indicates LAN1 activity.
Green indicates system hard drive activity.
Red indicates any system fault condition.
Solid green indicates the presence of DC power in the server.
Flashing green indicates that the system is in ACPI sleep mode.
H
F G
OM13424
133