Memory; Installing Dimms - Intel SPSH4 - Server Platform - 0 MB RAM Product Manual

Memory

This section includes instructions for removing and installing DIMMs on the memory board. For a
list of supported memory, call your service representative or visit the Intel Support website:
http://support.intel.com/support/motherboards/server/ssh4/spsh4/compat.htm

Installing DIMMs

CAUTION
Use extreme care when installing a DIMM. Applying too much pressure can
damage the socket. Keyed DIMMs insert only one way.
NOTE
Load the DIMMs in the following order (Figure 19).
1. Bank 1: DIMMs #1, 2, 3, and 4
2. Bank 2: DIMMs #5, 6, 7, and 8
3. Bank 3: DIMMs #9, 10, 11, and 12
Always fill banks completely. Partially filled banks are ignored by the
system.
Use only approved DIMMs listed on the Intel customer support Web site:
http://support.intel.com/support/motherboards/server/ssh4/spsh4/compat.htm
To install DIMMs:
1. Remove the memory board (page 69), and place the board component-side up on a
nonconductive, static-free surface.
2. Holding the DIMM only by its edges, remove it from its antistatic package.
82 Intel SPSH4 Server Platform Product Guide