Cd-Rom Drive Activity Light Does Not Light; Network Problems - Intel SPSH4 - Server Platform - 0 MB RAM Product Manual

CD-ROM Drive Activity Light Does Not Light

Check the following:
‰ Are the power and signal cables to the CD-ROM drive properly installed?
‰ Are all relevant switches and jumpers on the drive set correctly?
‰ Is the drive properly configured?
‰ Is the onboard IDE controller enabled in the BIOS?

Network Problems

The server hangs when the drivers are loaded.
‰ Change the PCI interrupt settings. Try the "PCI Installation Tips" below.
Diagnostics pass, but the connection fails.
‰ Make sure the network cable is securely attached.
‰ Make sure you specify the correct frame type in your NET.CFG file.
The Link LED does not light.
‰ Make sure you have loaded the network drivers.
‰ Check all cable connections.
‰ Try another port on the hub or switch.
‰ Make sure you have the correct type of cable between the adapter and the hub or switch. Some
hubs and switches require a crossover cable while others require a straight through cable. For
more information on crossover cabling, see your hub or switch documentation.
The Activity LED doesn't light.
‰ Make sure you've loaded the correct network drivers.
‰ The network might be idle. Try accessing a server.
The onboard network interface controller (NIC) stopped working when an add-in adapter
was installed.
‰ Make sure the cable is connected to the port from the onboard NIC.
‰ Make sure your PCI BIOS is current. Try the "PCI Installation Tips" below.
‰ Make sure the other adapter supports shared interrupts. Also, make sure your operating system
supports shared interrupts; OS/2
‰ Try reseating the add-in adapter.
The add-in adapter stopped working without apparent cause.
‰ Try reseating the adapter first; then try a different slot if necessary.
‰ The network driver files might be corrupt or deleted. Delete and then reinstall the drivers.
‰ Run the diagnostics.
126
†
does not.
Intel SPSH4 Server Platform Product Guide