Installing Memory - Intel SPSH4 - Server Platform - 0 MB RAM Product Manual

3. Open the plastic ejector levers at each end of the DIMM socket on the memory board
(Figure 19, A).
4. Orient the DIMM so that the notch in the bottom edge of the DIMM aligns with the keyed
socket on the memory board.
5. Insert the bottom edge of the DIMM into the socket and press down firmly on the DIMM until
it seats correctly. The plastic ejector levers should snap into place when the DIMM is seated.
6. Make sure that the plastic ejector levers on the socket ends are fully closed.
7. Reinstall the memory board (page 70).
Installing and Removing Components
A
11
9
7
5
3
1
Figure 19. Installing Memory
B
12
10
8
6
4
2
OM13272
83