Bmc Beep Codes; Error Messages And Codes - Intel SPSH4 - Server Platform - 0 MB RAM Product Manual

Table 20 lists the beep codes generated by the BMC.
Table 20. BMC Beep Codes
Beeps Reason
1-5-1-1 FRB failure (processor failure)
1-5-4-2 Power fault: DC power unexpectedly lost (power control failures)
1-5-4-3 Chipset control failure
1-5-4-4 Power control fault
Table 21 lists POST error codes and their associated messages. The BIOS prompts the user to press
a key in case of serious errors. Some of the error messages are preceded by the string "Error" to
highlight the fact that these indicate a system that might be malfunctioning. All POST errors and
warnings are logged in the system event log.
Table 21. Error Messages and Codes
Code Error Message
0200: Failure Fixed Disk
0210: Stuck Key
0211: Keyboard error
0212: Keyboard Controller Failed
0213: Keyboard locked – Unlock key switch
0220: Monitor type does not match CMOS – Run SETUP
0230: System RAM Failed at offset
0231: Shadow RAM Failed at offset
0232: Extend RAM Failed at address line
0233: Memory type mixing detected
0234: Single – bit ECC error
0235: Multiple- bit ECC error
0250: System battery is dead – Replace and run SETUP
0251: System CMOS checksum bad – Default configuration
used
0252: Password checksum bad - Passwords cleared
0260: System timer error
0270: Real time clock error
0271: Check date and time setting
02B0: Diskette drive A error
02B2: Incorrect Drive A type – run SETUP
02D0: System cache error – Cache disabled
0B00: Rebooted during BIOS boot at Post Code
Error Messages and Error Codes
Failure Description
Hard disk error
Keyboard connection error
Keyboard failure
Keyboard Controller Failed
Keyboard locked
Monitor type does not match CMOS
System RAM error
Offset address
Shadow RAM Failed
Offset address
Extended RAM failed
Offset address
Memory type mixing detected
Memory 1 bit error detected
Memory multiple-bit error detected
NVRAM battery dead
CMOS checksum error
System timer error
RTC error
RTC time setting error
Incorrect Drive A type
CPU cache error
continued
157