7b To enable the configuration status of any disabled service configuration, click the
Disabled link to change the status to Enabled.
7c To delay the configuration of newly installed services to a later time, click the Enabled
link to change the status to
8 When all the services have complete configuration information and the configuration or
reconfiguration status is set to Enable for the services that you want to configure, click Next to
continue with the configuration process.
4.3 Adding/Configuring OES Services on a
Server That Another Administrator Installed
To add or configure OES services on an OES server that another administrator installed, you must
have the rights described in
1 On the OES server, launch YaST. Then click Open Enterprise Server > OES Install and
Configuration.
2 On the Software Selection page, select the additional OES services you want to install, then
click Accept.
The required packages are installed.
3 When the Novell Open Enterprise Server Configuration summary screen appears, click the
disabled link under LDAP Configuration for Open Enterprise Services.
The link changes to enabled.
4 Click LDAP Configuration for Open Enterprise Services.
5 Change the Admin Name and Context.
IMPORTANT: Make sure all field delimiters are consistent. For example, if you are adding to
the context already displayed, either use comma-delimited syntax or change all other delimiters
to periods.
6 Type the subcontainer admin password in the Admin Password field, then click Next.
7 Go back to
Step 7 on page 105
4.4 What's Next
After you complete the configuration process, complete any additional tasks you might need to
perform. See
"Completing OES Installation or Upgrade Tasks" on page 143
(Patching) an OES 2 SP2 Server" on page
Configure is disabled
"Rights Required for Subcontainer Administrators" on page
and continue from there.
147.
Installing or Configuring OES 2 SP2 on an Existing Server 107
.
19.
and
"Updating