Novell Dhcp Services - Novell OPEN ENTERPRISE SERVER 2 SP2 Installation Manual

Page Parameter
Cluster IP Address: If you are creating a new cluster, specify a unique IP address for the
cluster.
The cluster IP address is separate from the server IP address and is required to be on the
same IP subnet as the other servers in the cluster.
Storage Device With Shared Media: If you are creating a new cluster, select the device
where the Split Brain Detector (SBD) partition will be created.
If you have a shared disk system attached to your cluster servers, Novell Cluster Services
creates a small cluster partition on that shared disk system. This small cluster partition is
referred to as the Split Brain Detector (SBD) partition. Specify the drive or device where you
want the small cluster partition created.
You must have at least 20 MB of free space on one of the shared disk drives to create the
cluster partition. If no free space is available, the shared disk drives cannot be used by
Novell Cluster Services.
If you do not have a shared disk system connected to your cluster servers, accept the default
(none). You must create the SBD manually before adding a second server to the cluster.
Default: none
Optional Device for Mirrored Partitions: If you want to mirror the SBD partition for greater
fault tolerance, select the device where you want to mirror to.
You can also mirror SBD partitions after installing Novell Cluster Services.
Novell Cluster Services (NCS) Configuration (2)
IP Address of this Node: This field contains the IP address of this node. If this server has
multiple IP addresses, you can change the default address to another value if desired.
Start Cluster Services Now: Select this box if you want clustering to start now. If you want
clustering to start after rebooting, or if you want to manually start it later, deselect this box.
This option applies only to installing Novell Cluster Services after the OES installation
because it starts automatically when the server initializes during the installation.
If you choose to not start Novell Cluster Services software, you need to either manually start
it after the installation, or reboot the cluster server to automatically start it.
You can manually start Novell Cluster Services by going to the
entering
./novell-ncs start
Default: Selected
For additional instructions, see the
Administration Guide.

3.6.7 Novell DHCP Services

Novell DHCP Services Parameters and Values
Table 3-11
Page Parameter
Novell DHCP Services Configuration
at the server console of the cluster server.
OES 2 SP2: Novell Cluster Services 1.8.7 for Linux
directory and
/etc/init.d
Installing OES 2 SP2
TM
81