Novell OPEN ENTERPRISE SERVER 2 SP2 Installation Manual page 117

Installation—Safe Settings: Boots the system with the DMA mode (for CD-ROM
drives) and power management functions disabled. Experts can also use the command line
to enter or change kernel parameters.
4 To proceed with the upgrade, your server must have
An IP address assigned.
The location of your network installation source.
To specify this information on the Boot Options line, proceed with
To supply the information in a series of dialog boxes, skip to
5 Specify the server's IP address information and the path to the installation source on the Boot
Options line (see "Using Custom Boot Options" in the SUSE Linux Enterprise Server
Installation and Administration Guide (http://www.novell.com/documentation/sles10/
book_sle_reference/data/
sec_deployment_remoteinst_bootinst.html#sec_deployment_remoteinst_bootinst_custom)).
Then press Enter and continue with
6 Press Enter.
The following error displays.
Could not find the SUSE Linux Enterprise Server 10 Installation source.
Activating manual set up program
7 Press Enter.
8 Select the language, then select OK and press Enter.
9 Select a keyboard map, then select OK and press Enter.
10 Select Start Installation or System, then select OK and press Enter.
11 Select Start Installation or Update, then select OK and press Enter.
12 Select Network, then select OK and press Enter.
13 Select the network protocol that matches the configured protocol on your network installation
server, then press Enter.
14 (Conditional) If you have more than one network interface card, select one of the cards, then
press Enter.
We recommend eth0, if it is connected to the subnet for the primary static IP address used by
the server you are upgrading.
15 When prompted whether you want to use DHCP, select No, then press Enter.
16 Specify the static IP address of the server you are upgrading, then press Enter.
17 Specify the subnet mask, then press Enter.
18 Specify the gateway, then press Enter.
19 Specify the IP addresses of a name server, then press Enter.
20 Specify the IP address of the network installation server, then press Enter.
21 (Conditional) Depending on the protocol you specified, you might see additional screens for
FTP or HTTP. Select the options that are appropriate for your network, then continue with
Step 22.
22 Specify the path to your installation source on the network installation server, then press Enter.
The installation system loads and the YaST install starts.
Step 23.
.
Step 5.
Step 6.
Upgrading to OES 2 SP2 117