Setting Up The Clock And Time Zone; Specifying The Installation Settings For The Sles Base And Oes Installation; Setting Up Disk Partitions - Novell OPEN ENTERPRISE SERVER 2 SP2 Installation Manual

3.3.4 Setting Up the Clock and Time Zone

1 Make sure the Clock, Region, Timezone, and Time and Date settings are what you want, then
click Next.
You can configure this information after the installation is complete, but it is easier to do it
during the installation.
2 Continue with
Installation," on page
3.3.5 Specifying the Installation Settings for the SLES Base
and OES Installation
The Installation Settings page lets you specify which software and services are installed on your
server.
Overview tab: This lets you specify everything that is normally required for an OES
installation.
Expert tab: This lets you fully customize your SLES installation settings. For detailed
information, see
book_sle_reference/data/part_setup.html)
Guide (http://www.novell.com/documentation/sles10/book_sle_reference/data/
book_sle_reference.html). Keep in mind, however, that the SLES guide does not contain
instructions for OES-specific components or configurations.
IMPORTANT: If you accept the defaults at this point in the installation process, only the base OES
components are installed.
You can add OES services later, but you should at least read the guidelines and follow the applicable
procedures in the following sections:
"Setting Up Disk Partitions" on page 48
"Customizing the Software Selections" on page 52
"Accepting the Installation Settings" on page 54

Setting Up Disk Partitions

In most cases, YaST proposes a reasonable partitioning scheme that can be accepted without
change. You can also use YaST to customize the partitioning.
"Guidelines" on page 49
"NSS on the System Disk" on page 50
"Security Flag Recommendations" on page 50
"Partitioning X86 Machines" on page 51
"Disk Partition Statistics" on page 51
"Combining Hard Disk Partitions" on page 52
48 OES 2 SP2: Installation Guide
Section 3.3.5, "Specifying the Installation Settings for the SLES Base and OES
48.
"Deployment" (http://www.novell.com/documentation/sles10/
in the SLES 10 SP3 Installation and Administration