Finishing The Upgrade; Post-Migration Imanager Configuration - Novell OPEN ENTERPRISE SERVER 2 SP2 Installation Manual

3c If you want to skip the configuration of a specific component and configure it later, click
Enabled in the Configuration is enabled status to change the status to Configuration is
disabled.
If you change the status to Configuration is disabled, you must configure the OES
components after the installation is complete. See
on an Existing Server" on page
4 After resolving all product configuration problems, click Next to proceed with the
configuration of all services and installation of iManager plug-ins.
5 When the Readme page displays, click Next and continue with
Upgrade," on page 139.

5.5 Finishing the Upgrade

After a successful configuration, YaST shows the Installation Completed page.
1 Deselect Clone This System for AutoYaST. Cloning is selected by default.
This increases the speed of finishing the installation update.
AutoYaST is a system for automatically installing one or more SUSE Linux Enterprise systems
without user intervention. Although you can create a profile from a system that has been
upgraded, it does not work to upgrade a similar system.
2 Finish the upgrade by clicking Finish on the Installation Completed page.
3 If you have upgraded a server that has NSS pools and volumes on the system device (the device
that contains the root (
3a Verify that the
is complete—
/dev/evms/sda1
partition is incomplete or doesn't contain
boot
3b Open a terminal and run the following command to ensure that the
created:
mkinitrd -f evms
3c Reboot the server before continuing with
on page 140.
A script runs automatically during the OES 2 SP2 Linux upgrade to install and enable
.
boot.evms
These changes are applied when you reboot your system after the upgrade is completed.
Make sure that you reboot after the upgrade and before you do anything that would alter
the changes made in this step.
4 After the server completes the upgrade, continue with
Successful" on page

5.6 Post-Migration iManager Configuration

If Role-Based Services are configuration in iManager, after upgrading iPrint to OES 2 SP2, the
Driver tab in iManager is missing. This is because support was added for Windows 7. To display
the new Driver tab, see the instructions in
search.do?cmd=displayKC&docType=kc&externalId=7004921&sliceId=2&docTypeID=DT_TID_
1_1&dialogID=66652408&stateId=1%200%2066654011).
103.
), , and partitions), you must do the following:
/ /boot swap
file is correct. For example, make sure that the path to
/etc/fstab
(or
hda1
140.
TID 7004921 (http://www.novell.com/support/php/
"Installing or Configuring OES 2 SP2
Section 5.5, "Finishing the
) and not just
/dev/evms
, change it and save the
/evms
"Verifying That the Upgrade Was Successful"
"Verifying That the Upgrade Was
/boot
. If the path to the
/
file.
fstab
file is correctly
initrd
Upgrading to OES 2 SP2 139