Finishing The Installation - Novell OPEN ENTERPRISE SERVER 2 SP2 Installation Manual

Configuring Novell Open Enterprise Server Services
1 After you complete the LDAP configuration or the eDirectory configuration, the Novell Open
Enterprise Server Configuration summary page is displayed, showing all the OES components
you installed and their configuration settings. Review the setting for each component and click
the component heading to change any settings.
When you specify the configuration information for OES services, see the information in
"Guidelines for Configuring OES 2 SP2 Components" on page
2 When you are satisfied with the settings for each component, click Next.
3 When you confirm the OES component configurations, you might receive the following error:
The proposal contains an error that must be resolved before continuing.
If this error is displayed, check the summary list of configured products for a message
immediately below each product heading. The list indicates the product or service needs to be
configured. If you are running the YaST graphical interface, the text appears red. If you are
installing through the YaST text-based interface, it is not red.
For example, if you have selected Linux User Management in connection with other OES
products or services, you might see a message similar to the following:
Linux User Management needs to be configured before you can continue or
disable the configuration
If you see a message like this, do the following:
3a On the summary page, click the heading for the component.
3b Supply the missing information in each configuration page.
When you specify the configuration information for OES services, see the information in
"Guidelines for Configuring OES 2 SP2 Components" on page
When you have finished the configuration of that component, you are returned to the
Novell Open Enterprise Server Configuration summary page.
3c If you want to skip the configuration of a specific component and configure it later, click
Enabled in the Configuration is enabled status to change the status to Configuration is
disabled.
If you change the status to Configuration is disabled, you will configure the OES
components after the installation is complete. See
on an Existing Server" on page
4 After resolving all product configuration problems, click Next to proceed with the
configuration of all components.
5 When the configuration has completed, continue with
on page 71.

3.4 Finishing the Installation

The installation concludes with the following steps:
1. User Authentication Method
2. Clean Up
3. Release Notes
4. Hardware Configuration
.
"Installing or Configuring OES 2 SP2
103.
Section 3.4, "Finishing the Installation,"
73.
73.
Installing OES 2 SP2 71