Novell OPEN ENTERPRISE SERVER 2 SP2 Installation Manual page 197

3 Click Destination Address, specify a valid NetWare server name for the virtualized NetWare
server, and specify the IP address you want the virtualized server to use.
The IP address must be unique on the subnet just as it would be for a physical NetWare
installation.
4 Click Next.
5 Click Destination eDirectory.
6 Specify the name of the eDirectory tree and a context for this server object.
7 In the Replica Server IP Address field, specify the IP address of the eDirectory server.
8 In the User Information section, specify the admin information for the tree, then click Next.
9 Click License, specify the eDirectory container where you want the NetWare license files
stored (usually the Organization object), then click Next.
10 Click Protocols.
11 Specify the Subnet Mask and Gateway information for the subnet and click Next.
12 Click Language, change the language settings if needed, then click Next.
13 Click SLP Configuration.
14 If your tree has more than three servers, you must specify valid SLP information before
continuing. Otherwise, you can leave the page at the default settings.
After you are finished with the page, click Next.
15 Click DNS Configuration, specify the DNS information, then click Next.
16 Click Time Zone Configuration, select your time zone options, then click Next.
17 Click Time Sync Configuration.
18 Leave the protocol set to TimeSync (do not select NTPv3), select Use TIMESYNC Configured
Sources, specify the same time synchronization source as your eDirectory server uses, select
NTP if applicable, then click Next.
19 Click Install Settings, change the default settings if needed, add any needed SET parameters by
clicking Edit, then click Next.
20 Click Storage Configuration, adjust the default sizes if desired, then click Next.
21 Click Pattern Selection, select the preconfigured server pattern you want installed, then click
Next.
22 If you selected Customized NetWare Server in
services you want installed, then click Next.
23 Click NMAS Configuration > Next > Next.
24 (Conditional) Depending on what products you selected for the server, click the headings and
enter the required information until all the configuration options have been completed for the
response file.
25 On the Save Response File page, specify a response filename, then browse to the directory
where you stored your NetWare license files. (If you completed all of the instructions in
Section 11.4.1, "Preparing the Installation Media," on page
that ends with a forward slash (/).
26 If you want the VM Manager to launch automatically after you exit the Response File
Generator, select Launch VM Manager.
Step 21, click Product Selection, select the
196, the field should show a path
Installing and Managing NetWare on a Xen-based VM 197