Route Information - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual

The following table describes the Layer 3 Information Menu options.
Table 26 Layer 3 information menu options
Command
route
arp
*ospf
*rip
ip
igmp
*vrrp
dump
* indicates menus that are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.

Route information

Command: /info/l3/route
[IP Routing Menu]
find
gw
type
tag
if
dump
Using the commands listed below, you can display all or a portion of the IP routes currently held in the switch.
Table 27 Route Information menu options
Command
find <IP address>
gw <IP address>
type
indirect|direct|local|
broadcast|martian|multicast
tag
fixed|static|addr|rip|ospf|
broadcast|martian|multicast
if <IP address>
dump
Usage
Displays the IP Routing Menu. Using the options of this menu, the system displays the following for
each configured or learned route:
Route destination IP address, subnet mask, and gateway address
Type of route
Tag indicating origin of route
Metric for RIP tagged routes, specifying the number of hops to the destination (1-15 hops, or
16 for infinite hops)
The IP interface that the route uses
Displays the Address Resolution Protocol (ARP) Information Menu.
Displays OSPF routing Information Menu.
Displays Routing Information Protocol Menu.
Displays IP Information. IP information, includes:
IP interface information: Interface number, IP address, subnet mask, VLAN number, and
operational status.
Default gateway information: Metric for selecting which configured gateway to use, gateway
number, IP address, and health status
IP forwarding information: Enable status, lnet and lmask
Port status
Displays IGMP Information Menu.
Displays the VRRP Information Menu.
Dumps all switch information available from the Layer 3 Menu (10K or more, depending on your
configuration).
If you want to capture dump data to a file, set your communication software on your workstation
to capture session data prior to issuing the dump commands.
- Show a single route by destination IP address
- Show routes to a single gateway
- Show routes of a single type
- Show routes of a single tag
- Show routes on a single interface
- Show all routes
Usage
Displays a single route by IP address. For example,
100.10.1.1
Displays routes to a single gateway. For example,
100.10.1.2
Displays routes of a single type.
Displays routes of a single tag.
Displays routes on a single interface.
Displays all routes configured in the switch.
Information Menu 44