Layer 3 Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual

The commands in this menu configure VLAN attributes, change the status of the VLAN, delete the VLAN, and change
the port membership of the VLAN.
By default, the VLAN menu option is disabled except VLAN 1, which is always enabled. The GbE2c supports a
maximum of 1,000 VLANs. VLAN 4095 is reserved for switch management.
NOTE: See the HP GbE2c Ethernet Blade Switch for c-Class BladeSystem Application Guide for information on
VLANs.
The following table describes the VLAN Configuration Menu options.
Table 120 VLAN Configuration Menu options
Command
name <1-32 characters>
stg <1-32>
add <port number>
rem <port number>
def <list of port numbers>
ena
dis
del
cur
IMPORTANT: All ports must belong to at least one VLAN. Any port which is removed from a VLAN and which
is not a member of any other VLAN is automatically added to default VLAN #1. You cannot remove a port
from VLAN #1 if the port has no membership in any other VLAN. Also, you cannot add a port to more than
one VLAN unless the port has VLAN tagging turned on. See the tag command, in the "Port configuration"
section earlier in this chapter.

Layer 3 configuration

Command: /cfg/l3
[Layer 3 Menu]
if
gw
route
arp
frwd
nwf
rmap
rip
ospf
igmp
dns
bootp
vrrp
cur
The following table describes the Layer 3 Configuration Menu options.
Table 121 L3 Configuration Menu options
Command
if <1-256>
gw <1-4>
*route
arp
Description
Assigns a name to the VLAN or changes the existing name. The default
VLAN name is the first one.
Assigns a VLAN to a spanning tree group.
Adds ports to the VLAN membership.
Removes ports from the VLAN membership.
Defines which ports are members of this VLAN. Every port must be a
member of at least one VLAN. By default, it defines ports to VLAN 1.
Enables this VLAN.
Disables this VLAN without removing it from the configuration.
Deletes this VLAN.
Displays the current VLAN configuration.
- Interface Menu
- Default Gateway Menu
- Static Route Menu
- ARP Menu
- Forwarding Menu
- Network Filters Menu
- Route Map Menu
- Routing Information Protocol Menu
- Open Shortest Path First (OSPF) Menu
- IGMP Menu
- Domain Name System Menu
- Bootstrap Protocol Relay Menu
- Virtual Router Redundancy Protocol Menu
- Display current IP configuration
Description
Displays the IP Interface Menu.
Displays the IP Default Gateway Menu.
Displays the IP Static Route Menu.
Displays the ARP (Address Resolution Protocol) Menu.
Configuration Menu 122