Panic Command; Unscheduled System Dumps - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual
Hp gbe2c ethernet blade switch for c-class bladesystem command reference guide
Hide thumbs
Also See for GbE2c - Blc Layer 2/3 Fiber SFP Option:
- Interface manual (209 pages) ,
- Application manual (165 pages) ,
- Cli reference manual (153 pages)
Table of Contents
Advertisement
Panic command
Command: /maint/panic
The panic command causes the switch to immediately dump state information to flash memory and automatically
reboot.
To select panic, at the Maintenance# prompt, enter:
>> Maintenance# panic
A FLASH dump already exists.
Confirm replacing existing dump and reboot [y/n]:
Enter y to confirm the command:
Confirm dump and reboot [y/n]: y
A list of messages is displayed:
Starting system dump...done.
Reboot at 11:54:08 Wednesday October 30, 2006...
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Rebooted because of console PANIC command.
Booting complete
Unscheduled system dumps
If there is an unscheduled system dump to flash memory, the following message is displayed when you log on to the
switch:
Note: A system dump exists in FLASH. The dump was saved
at 13:43:22 Wednesday October 30, 2006. Use /maint/uudmp to
extract the dump for analysis and /maint/cldmp to
clear the FLASH region. The region must be cleared
before another dump can be saved.
Maintenance Menu 172
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the GbE2c - Blc Layer 2/3 Fiber SFP Option and is the answer not in the manual?