Forwarding Database Configuration; Static Fdb Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual

Table 112 Spanning Tree Port Configuration Menu options
Command
link auto|p2p|shared
edge disable|enable
fastfwd disable|enable
on
off
cur

Forwarding Database configuration

Command: /cfg/l2/fdb
[FDB Menu]
static
aging
cur
The following table describes the Forwarding Database Configuration Menu options.
Table 113 FDB Configuration Menu options
Command
static
aging <0-65535>
cur

Static FDB configuration

Command: /cfg/l2/fdb/static
[Static FDB Menu]
add
del
clear
cur
Description
Defines the type of link connected to the port, as follows:
auto: Configures the port to detect the link type, and automatically match its settings.
p2p: Configures the port for Point-To-Point protocol.
shared: Configures the port to connect to a shared medium (usually a hub).
This command only applies when RSTP is turned on. See the "Common Internal
Spanning Tree configuration" section for more information.
Enables or disables this port as an edge port. An edge port is not connected to a
bridge, and can begin forwarding traffic as soon as the link is up. Configure server
ports as edge ports (enabled).
This command only applies when RSTP is turned on. See the "Common Internal
Spanning Tree configuration" section for more information.
Enables or disables Port Fast Forward on the port.
Enables STP on the port.
Disables STP on the port.
Displays the current STP port parameters.
- Static FDB Menu
- Configure FDB aging value
- Display current FDB configuration
Description
Displays the Static FDB Configuration Menu.
Configures the aging value for FDB entries. The default value is 300.
Displays current FDB parameters.
- Add a permanent FDB entry
- Delete a static FDB entry
- Clear static FDB entries
- Display current static FDB configuration
Configuration Menu 118