Operations-Level Port 802.1X Options; Operations-Level Vrrp Options - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual

Operations-level port 802.1x options

Command: /oper/port <port number>/8021x
[802.1x Operation Menu]
reset
reauth
Operations-level port 802.1x options are used to temporarily set 802.1x parameters for a port.
Table 183 Operations-Level Port 802.1x Menu options
Command
reset
reauth

Operations-level VRRP options

Command: /oper/vrrp
[VRRP Operations Menu]
back
NOTE: This menu is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
Operations-level VRRP options are described in the following table.
Table 184 Operations-Level VRRP Menu options
Command
back <1-255>
- Reinitialize 802.1x access control on this port
- Initiate reauthentication on this port now
Description
Re-initializes the 802.1x access-control parameters for the port. The following actions take
place, depending on the 802.1x port configuration:
- the port is placed in unauthorized state, and traffic is blocked.
force unauth
- the port is placed in unauthorized state, then authentication is initiated.
auto
- the port is placed in authorized state, and authentication is not
force auth
required.
Re-authenticates the supplicant (client) attached to the port. This command only applies if
the port's 802.1x mode is configured as
- Set virtual router to backup
Description
Forces the specified master virtual router on this switch into backup mode. This is generally
used for passing master control back to a preferred switch once the preferred switch has
been returned to service after a failure. When this command is executed, the current master
gives up control and initiates a new election by temporarily advertising its own priority
level as 0 (lowest). After the new election, the virtual router forced into backup mode by
this command will resume master control in the following cases:
This switch owns the virtual router (the IP addresses of the virtual router and its IP
interface are the same)
This switch's virtual router has a higher priority and preemption is enabled.
There are no other virtual routers available to take master control.
.
auto
Operations Menu 161