HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual page 107

Table 99 Port Configuration Menu options
Command
gig
aclqos
8021ppri
pvid <1-4095>
name <1-64 characters>|none
rmon enable|disable
tag enable|disable
tagpvid enable|disable
*media
*fiber
*copper
*automedia
brate <0-262143>|dis
mrate <0-262143>|dis
drate <0-262143>|dis
ena
dis
cur
* indicates commands that are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
Description
Displays the Gigabit Ethernet Physical Link Menu.
Displays the Access Control List (ACL)/Quality of Service (QoS)
configuration menu.
Configures the port's 802.1p priority level.
Sets the default VLAN number which will be used to forward frames
which are not VLAN tagged. The default number is 1.
Note: VLAN 4095 is reserved for switch management.
Sets a name for the port (maximum 64 characters). The assigned port
name displays next to the port number on some information and statistics
screens.
Enables or disables Remote Monitoring for the port. RMON must be
enabled for any RMON configurations to function.
Disables or enables VLAN tagging for this port. It is disabled by default.
Disables or enables VLAN tag persistence. When disabled, the VLAN tag
is removed from packets whose VLAN tag matches the port PVID. The
default value is enabled.
Displays the current port's transmission media:
auto
This option is only available on uplink ports.
This option applies only to the GbE2c Layer 2/3 Ethernet Blade Switch.
Configures the port's transmission media as
This option is only available on uplink ports.
This option applies only to the GbE2c Layer 2/3 Ethernet Blade Switch.
Configures the port's transmission media as
This option is only available on uplink ports.
This option applies only to the GbE2c Layer 2/3 Ethernet Blade Switch.
Configures the port's transmission media as
This option is only available on uplink ports.
This option applies only to the GbE2c Layer 2/3 Ethernet Blade Switch.
Limits the number of broadcast packets per second to the specified value.
If disabled ( ), the port forwards all broadcast packets.
dis
Limits the number of multicast packets per second to the specified value. If
disabled ( ), the port forwards all multicast packets.
dis
Limits the number of unknown unicast packets per second to the specified
value. If disabled ( ), the port forwards all unknown unicast packets.
dis
Enables the port.
Disables the port. To temporarily disable a port without changing its
configuration attributes, see the "Temporarily disabling a port" section
later in this chapter.
Displays current port parameters.
, , or
copper fiber
.
fiber
.
copper
.
auto
Configuration Menu 107