Reminders; System Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual

You can view all pending configuration changes that have been applied but not saved to flash memory using the diff
flash command. It is a global command that can be executed from any prompt.
For instructions on selecting the configuration to run at the next system reset, see the "Selecting a configuration block"
section in the "Boot Options Menu" chapter.

Reminders

CLI reminders prompt users to complete configuration tasks that require multiple steps. The default setting for CLI
reminders is enabled. Use the following command to disable CLI reminders: /cfg/sys/reminders dis
The following is an example of a configuration task performed with CLI reminders enabled.
>> Layer 2# vlan 5
VLAN number 5 with name "VLAN 5" created.
Reminder: VLAN 5 needs to be enabled.
>> VLAN 5# add 9
Port 9 is an UNTAGGED port and its current PVID is 1.
Confirm changing PVID from 1 to 5 [y/n]: y
Current ports for VLAN 5:
Pending new ports for VLAN 5:
Reminder: Port 9 needs to be enabled.
Reminder: VLAN 5 needs to be enabled.

System configuration

Command: /cfg/sys
[System Menu]
syslog
sshd
radius
tacacs+
ntp
ssnmp
access
date
time
timezone
idle
notice
bannr
hprompt
bootp
dhcp
reminders - Enable/disable Reminders
cur
This menu provides configuration of switch management parameters such as user and administrator privilege mode
passwords, browser-based management settings, and management access list.
The following table describes the System Configuration Menu options.
Table 78 System Configuration Menu options
Command
syslog
sshd
radius
tacacs+
ntp
ssnmp
access
empty
9
- Syslog Menu
- SSH Server Menu
- RADIUS Authentication Menu
- TACACS+ Authentication Menu
- NTP Server Menu
- System SNMP Menu
- System Access Menu
- Set system date
- Set system time
- Set system timezone (daylight savings)
- Set timeout for idle CLI sessions
- Set login notice
- Set login banner
- Enable/disable display hostname (sysName) in CLI prompt
- Enable/disable use of BOOTP
- Enable/disable use of DHCP on Mgmt interface
- Display current system-wide parameters
Usage
Displays the Syslog Menu.
Displays the SSH Server Menu.
Displays the RADIUS Authentication Menu.
Displays the TACACS+ Menu.
Displays the Network Time Protocol (NTP) Server Menu.
Displays the System SNMP Menu.
Displays the System Access Menu.
Configuration Menu 90