Information Menu Introduction; Menu Overview - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual

Information Menu
Introduction
You can view configuration information for the switch in the user, operator, and administrator command modes. This
chapter discusses how to use the CLI to display switch information.

Menu overview

Command: /info
[Information Menu]
sys
l2
l3
qos
acl
rmon
link
port
geaport
ufd
dump
The following table describes the Information Menu options.
Table 6 Information Menu options
Command
sys
l2
l3
qos
acl
rmon
link
port
geaport
ufd
dump
- System Information Menu
- Layer 2 Information Menu
- Layer 3 Information Menu
- QoS Menu
- Show ACL information
- Show RMON information
- Show link status
- Show port information
- Show system port and gea port mapping
- Show Uplink Failure Detection information
- Dump all information
Usage
Displays system information.
Displays the Layer 2 Information Menu.
Displays the Layer 3 Information Menu.
Displays the Quality of Service (QoS) Information Menu.
Displays the Access Control List Information Menu.
Displays the Remote Monitoring Information Menu.
Displays configuration information about each port, including:
Port number
Port speed (10 Mb/s, 100 Mb/s, 1000 Mb/s, or any)
Duplex mode (half, full, or any)
Flow control for transmit and receive (no, yes, or any)
Link status (up or down)
Displays port status information, including:
Port number
Whether the port uses VLAN tagging or not
Port VLAN ID (PVID)
Port name
VLAN membership
Displays GEA port mapping information, used by service personnel.
Displays Uplink Failure Detection information
Dumps all switch information available from the Information Menu (10K or more, depending on
your configuration).
If you want to capture dump data to a file, set your communication software on your workstation to
capture session data prior to issuing the dump commands.
Information Menu 22