HEIDENHAIN ITNC 530 - CONVERSATIONAL PROGRAMMING User Manual page 322

Group name, ID no.
Status of M128, 280
Status of M116, 310
Current system time of the TNC,
320
TS triggering touch probe, 350
TT tool touch probe
Last touch point in TCH PROBE
Cycle 0 or last touch point from
manual operating mode, 360
Value from the active datum
table in the active coordinate
system, 500
REF value from the active datum
table, 501
Read value from the preset
table, considering the machine
kinematics, 502
Read value directly from the
preset table, 503
322
Number Index
9
1 -
2 -
116 -
128 -
144 -
1 0
10 -
11 -
12 -
13 -
14 1
2
15 -
20 1
2
3
21 -
1 1 to 9
2 1 to 9
Datum 1 to 9
number
Datum 1 to 9
number
Preset 1 to 9
number
Preset 1 to 9
number
Meaning
W axis
0: M128 inactive, value not equal to 0: M128 active
Feed rate that was programmed with M128
0: M116 inactive, value not equal to 0: M116 active
0: M128 inactive, value not equal to 0: M128 active
0: M144 inactive, value not equal to 0: M144 active
System time in seconds that have elapsed since 00:00
of January 1, 1970
Touch probe axis
Effective ball radius
Effective length
Radius setting ring
Center offset (reference axis)
Center offset (minor axis)
Direction of center misalignment compared with 0°
position
Center point X axis (REF system)
Center point Y axis (REF system)
Center point Z axis (REF system)
Probe contact radius
Position in the active coordinate system in axes 1 to 9
Position in the REF system in axes 1 to 9
X axis to W axis
X axis to W axis
X axis to W axis
X axis to W axis
Programming: Q Parameters