HEIDENHAIN ITNC 530 - CONVERSATIONAL PROGRAMMING User Manual page 319

Group name, ID no.
Pocket table data, 51
Tool pocket, 52
File information, 56
Position programmed
immediately after TOOL CALL, 70
HEIDENHAIN iTNC 530
Number Index
24 Tool no.
25 Tool no.
26 Tool no.
27 Tool no.
28 Tool no.
No index: Data of the currently active tool
1 Pocket number
2 Pocket number
3 Pocket number
4 Pocket number
5 Pocket number
6 Pocket number
7 to 11 Pocket number
12 Pocket number
13 Pocket number
14 Pocket number
15 Pocket number
16 Pocket number
1 Tool no.
2 Tool no.
1 -
2 -
3 Q parameter
number, as of
which the status
of the axes is
stored. +1: axis
active, -1: axis
inactive
1 -
2 1
Meaning
TS: Center misalignment in reference axis
TS: Center misalignment in minor axis
TS: Spindle angle for calibration
Tool type for the pocket table
Maximum speed
Tool number
Special tool: 0=no, 1=yes
Fixed pocket: 0=no, 1=yes
Locked pocket: 0=no, 1=yes
PLC status
Tool type
Value from column P1 to P5
Pocket reserved: 0=no, 1=yes
Box magazine: Pocket above locked (0=no, 1=yes)
Box magazine: Pocket below locked (0=no, 1=yes)
Box magazine: Pocket to the left locked (0=no, 1=yes)
Box magazine: Pocket to the right locked (0=no,
1=yes)
Pocket number P
Tool magazine number
Number of lines in the tool table TOOL.T
Number of lines in the active datum table
Number of active axes that are programmed in the
active datum table
Position valid / invalid (0/0)
X axis
319