Automatic Program Start - HEIDENHAIN ITNC 530 - CONVERSATIONAL PROGRAMMING User Manual

16.5 Automatic Program Start

Application
The TNC must be specially prepared by the machine tool
builder for use of the automatic program start function.
Refer to your machine tool manual.
In a Program Run operating mode, you can use the AUTOSTART soft
key (see figure at upper right) to define a specific time at which the
program that is currently active in this operating mode is to be started:
U Show the window for entering the starting time (see
figure at center right).
U Time (h:min:sec): Time of day at which the program
is to be started.
U Date (DD.MM.YYYY): Date at which the program is to
be started.
U To activate the start, set the AUTOSTART soft key to
ON.
HEIDENHAIN iTNC 530 613