Defining The Ip Address On The Processor Unit Network Adapter For Communication With The Transceiver - Simrad EK80 Quick Start Manual

Procedure
1 On the menu, select
Setup
2 On the left side of the
3 Select
Type License String
4 Select to save the license string and close the
OK
5 Verify that the license string is placed in the
6 Select and then
Apply
box.
Defining the IP address on the Processor Unit
network adapter for communication with the
transceiver
The Processor Unit and the transceiver(s) communicate on a high capacity Ethernet cable.
If more than one transceiver is used, an Ethernet switch is added. On the Processor Unit,
define the IP address and Subnet mask for the Ethernet port used to communicate with the
transceiver(s). The EK80 automatically assigns an IP address to each transceiver when
they are turned off and on.
Context
This procedure is only performed once, unless you make changes to your system.
Procedure
1 On the Processor Unit, close the EK80 program.
2 Open the
Network Connections
3 Select
Use the following IP address
• : 157.237.15.12
IP Address
IP address for the transceiver network adapter.
Any address can be used, but 157.237.15.12 is recommended for legacy reasons.
This is particularly important if your system contains old GPT transceivers.
• : 255.255.255.0
Subnet mask
403825/C
.
Installation
dialog box, select
Installation
, and type the license string into the dialog box.
to save all the parameters and close the
Close
dialog box.
, and type the IP address and network mask.
Setting the EK80 system to work
Software License
Type License String
Currently active licenses
.
dialog box.
list.
dialog
Installation
11