Resolving Voice Quality And Roaming Problems; Symptom: Cisco Wireless Ip Phone Resets Unexpectedly; Verifying Access Point Settings - Cisco 7920 - Unified Wireless IP Phone VoIP Administration Manual

Chapter 9 Troubleshooting the Cisco Wireless IP Phone 7920

Resolving Voice Quality and Roaming Problems

Symptom: Cisco Wireless IP Phone Resets Unexpectedly

Verifying Access Point Settings

Cisco Wireless IP Phone 7920 Administration Guide for Cisco CallManager Release 4.0 and 4.1
OL-7104-01
Cisco Wireless IP Phone 7920 users might have problems with voice quality and
connectivity when roaming with their phones. See the following sections for
troubleshooting information:
Symptom: Cisco Wireless IP Phone Resets Unexpectedly, page 9-11
•
Symptom: The Cisco Wireless IP Phone Has Audio Problems, page 9-14
•
Symptom: The Cisco Wireless IP Phone Does Not Roam Properly, page 9-15
•
If users report that their phones are resetting during calls or resetting while idle
on their desk, you should investigate the cause. If the network connection and
Cisco CallManager connection are stable, a Cisco Wireless IP Phone 7920 should
not reset on its own.
Typically, a phone resets if it has problems connecting to the access point and
LAN or to Cisco CallManager. These sections can help you identify the cause of
a phone resetting in your network:
Verifying Access Point Settings, page 9-11
•
Identifying Intermittent Network Outages, page 9-12
•
Verifying DHCP Settings, page 9-12
•
Verifying Voice VLAN Configuration, page 9-12
•
Verifying that the Phones Have Not Been Intentionally Reset, page 9-13
•
• Eliminating DNS or Other Connectivity Errors, page 9-13
Verify that the wireless configuration is correct. For example, check if the
particular access point or switch to which the phone is connected is down. See the
"Wireless Network and Access Point Configuration" section on page 2-19
information about access point settings.
Resolving Voice Quality and Roaming Problems
for
9-11