Cisco 7920 - Unified Wireless IP Phone VoIP Administration Manual page 54

Wireless Network and Access Point Configuration
Table 2-4 Cisco Aironet Access Point Configuration Tasks
Activity
Check that the
Cisco IOS version is the
recommended version
Configure a VLAN for
voice
Configure Service Set
Identifier (SSID) for
each VLAN
Configure QoS settings
for VLANs
Enable ARP caching
Cisco Wireless IP Phone 7920 Administration Guide for Cisco CallManager Release 4.0 and 4.1
2-20
Cisco Aironet Access Point 1300 series
•
Table 2-4 explains and provides references for many of the configuration
activities for the Cisco Aironet Access Point.
Explanation
Under System Software, check for
Cisco IOS version 12.2(15)JA or later.
To isolate voice traffic and enable QoS,
you need a separate voice VLAN on the
access point and network switch.
Identifier for a set of wireless devices
to communicate with each other.
Several access points can have the same
SSID to support a group of wireless
phones.
Create a QoS policy for the voice
VLAN and assign a higher CoS to voice
traffic.
Enable the QoS element for wireless IP
phones to provide channel utilization
(QBSS) information to phones.
Enable this option to ensure two-way
audio. The access point has ARP
caching disabled by default.
Chapter 2 An Overview of the Wireless Network
Reference
Refer to the Cisco Wireless
IP Phone 7920 Design and
Deployment Guide
Interacting with the Cisco Aironet
Access Point, page 2-8
Refer to the Cisco Wireless
IP Phone 7920 Design and
Deployment Guide
Voice Quality in a Wireless
Network, page 2-12
Refer to the Cisco Wireless
IP Phone 7920 Design and
Deployment Guide
Interacting with the Cisco Aironet
Access Point, page 2-8
Refer to the Cisco Wireless
IP Phone 7920 Design and
Deployment Guide
Voice Quality in a Wireless
Network, page 2-12
Refer to the Cisco Wireless
IP Phone 7920 Design and
Deployment Guide
OL-7104-01