Cisco 7920 - Unified Wireless IP Phone VoIP Administration Manual page 112

Overview of the Application Windows
Editing Messages and Selecting the Ring Tone
Step 1
Step 2
Step 3
Step 4
Configuring Advanced Settings
Cisco Wireless IP Phone 7920 Administration Guide for Cisco CallManager Release 4.0 and 4.1
4-26
Set parameters for Cisco Discovery Protocol (CDP)
–
Choose the language for the user interface
–
Choose softkey settings
–
Control back light
–
To configure messages and ring tone, follow these steps:
Procedure
In the Phone Profile window, click the Phone Settings tab.
In the Greeting Message field, enter or edit the text (up to 15 characters) that
displays when you start up the phone.
In the Welcome Message field, enter or edit the text (up to 10 characters) that
displays when the phone is in stand-by mode.
In the Ring Tone area, you must configure a ring tone using the following settings:
Current Ring Tone—Displays the current ring tone set on the Cisco Wireless
•
IP Phone 7920. There are two default ring tones: Chirp 1 and Chirp 2.
Ring List (*.xml)—To specify a local XML Ring List file, click the "..."
•
button , and choose the desired Ring List File.
Ring Tone—Click the arrow by the drop-down list, and choose the desired
•
ring tone from the Ring List File.
To add the louder ring tones to the ring tone list, see the
Tones" section on page
Use the Advanced Settings section in the Phone Settings page to select options
that control the phone:
Chapter 4
7-14.
Using the Cisco 7920 Configuration Utility
"Downloading Loud Ring
OL-7104-01