Save Changes & Exit; Discard Changes & Exit; Get Default Values - NEC POWERMATE VP Manual

Save Changes & Exit
Discard Changes & Exit

Get Default Values

2-22 Setting System Parameters
After making your selections on the Setup menus, always
select Save Changes to make them operative.
After you save your selections, the program displays this
message:
Changes have been saved
If you attempt to exit without saving, the program asks if
you want to save before exiting.
During bootup, Setup attempts to load the values you
saved in NVRAM. If the values saved in NVRAM cause
the system boot to fail, reboot and press
In Setup, you can load the ROM default values (as de-
scribed in "Get Default Values") or try to change the val-
ues that caused the boot to fail.
Use this option to exit Setup without recording any
changes you may have made.
To load all the default Setup values in the Setup menus,
select Load ROM Default Values from the Main Menu.
The program displays this message:
Default values have been loaded!
If, during bootup, the BIOS program detects a problem in
the integrity of values stored in NVRAM, it displays these
messages:
System CMOS checksum bad - run SETUP
Press <F1> to resume, <F2> to Setup
Continue
Continue
to enter Setup.
F2