Printronix P7010 User Manual page 283

Table 15. LCD Message Troubleshooting Table
Displayed Message
SPX FOUND, ERROR: No
KEY NOT DETECTED
SPX NOT NEEDED No
OPTIONS ENABLED
STACK OVERFLOW* No
STACK UNDERFLOW* No
STACKER FAULT Yes
STACKER FULL Yes
STACKER JAM Yes
TCB CORRUPTED* No
TCP PORT BUSY Yes
UNDEF INTERRUPT* No
UNDFNED OPCODE* No
Can User
Explanation
Correct?
The controller board does
not have a security key.
The user has attempted
to use the SPX to turn on
printer options that are
already enabled.
Firmware error on
controller board.
Firmware error on the
controller board.
Stacker is not functioning
correctly.
Status message: the
power paper stacker is
full of paper.
This message is
triggered if there is paper
inside the throat of the
stacker elevator, but the
elevator is not moving.
Task Control Block
Corrupted. Firmware
error on controller board.
Error message reported
by the Printer Manager
when ethernet interface
option is installed. The
network address given in
the printer properties was
reached, but the printer
port is busy.
Undefined Interrupt.
Firmware error on
controller board.
Undefined Opcode.
Firmware error on
controller board.
Fault Messages
Solution
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
Check for obstructions in the
stacker area. If fault persists,
contact your authorized service
1
representative.
Unload the stacker. If fault persists,
contact your authorized service
1
representative.
1. Open the cabinet rear door and
check for obstructions preventing
elevator movement. Remove any
obstructions.
2. Run the print job again. If the
message appears again, contact
your authorized service
1
representative.
Contact your authorized service
1
representative.
Refer to the Printronix P7000
Maintenance Manual .
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
283