Set The Tear Bar Distance - Printronix P7010 User Manual

Set The Tear Bar Distance

To set the tear bar distance, do the following steps:
1. Make sure the printer is offline.
2. Press the right arrow
3. Press the down arrow
4. Press the right arrow
5. Press the down arrow
6. Press the Enter key. A scale prints to indicate the tear bar distance in
relation to the tear bar.
7. Press the left arrow
bar distance in increments of 1/144th of an inch.
8. Press Enter to select the desired value. An asterisk appears next the
selected value.
9. Press Enter again to print a new scale. For correct tear bar distance, the
zero should align with the tear bar. See Figure 35.
+50
-50
Print Station
Figure 35. Correct Tear Bar Distance
NOTE: When a new ZTP Tear Bar Dist value is selected, the printer will lose
the current print position until you reset the top of form to
automatically save the new value.
10. Reset the top of form using the procedure on page 300.
Set The Tear Bar Distance
until "OFFLINE/ZTP SETTINGS" displays.
. "ZTP DataTime" displays.
until "ZTP TearDist" displays.
. "ZTP TearDist/xx/144 Inch" displays.
or right arrow to decrease or increase the tear
Physical TearBar
0
Position
Correct
TearBar
Distance
299