Printronix P7010 User Manual page 261

Table 15. LCD Message Troubleshooting Table
Displayed Message
DP FIFO Busy* Yes
DRVR CIR BAD* No
E00 EXE @ ADDR0 Yes
See User Manual
E01A TYPE 0x40 Yes
See User Manual
E01B TYPE 0x60 Yes
See User Manual
Can User
Explanation
Correct?
There is a timing problem
in the Engine Controller
firmware.
Driver Circuit Bad. The
hammer coil count test
failed.
An illegal or unsupported
instruction was attempted
in the application
program.
An illegal or unsupported
instruction was attempted
in the application
program.
An illegal or unsupported
instruction was attempted
in the application
program.
Fault Messages
Solution
1. Cycle power. Run the print
job again. If the message
appears, download the
emulation software again.
2. Cycle power. Run the print
job again. If the message
appears again, contact your
authorized service
1
representative.
Contact your authorized service
1
representative.
1. Cycle Power. Run the print
job again. If the message
appears, load the latest
emulation software.
2. Cycle power. Run the print
job again. If the message
appears, record the display
message and send it to your
next higher support facility.
1. Cycle Power. Run the print
job again. If the message
appears, load the latest
emulation software.
2. Cycle power. Run the print
job again. If the message
appears, record the display
message and send it to your
next higher support facility.
1. Cycle Power. Run the print
job again. If the message
appears, load the latest
emulation software.
2. Cycle power. Run the print
job again. If the message
appears, record the display
message and send it to your
next higher support facility.
261