D-Link TM DES-6500 Cli Manual page 84

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
Example usage:
To create a spanning tree instance 2:
config stp instance_id
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure instance ID 2 to add VID 10:
Example usage:
To remove VID 10 from instance ID 2:
DES-6500:4#create stp instance_id 2
Command: create stp instance_id 2
Success.
DES-6500:4#
Used to add or delete an STP instance ID.
config stp instance_id <value 1-15> [add_vlan | remove_vlan]
<vidlist>
This command is used to map VIDs (VLAN IDs) to previously
configured STP instances on the Switch by creating an instance_id. A
STP instance may have multiple members with the same MSTP
configuration. There is no limit to the number of STP regions in a
network but each region only supports a maximum of 16 spanning tree
instances (one unchangeable default entry). VIDs can belong to only
one spanning tree instance at a time.
Note that switches in the same spanning tree region having the same
STP instance_id must be mapped identically, and have the same
configuration revision_level number and the same name.
<value 1-15> - Enter a number between 1 and 15 to define the
instance_id. The Switch supports 16 STP regions with one
unchangeable default instance ID set as 0.
add_vlan – Along with the vid_range <vidlist> parameter, this
command will add VIDs to the previously configured STP
instance_id.
remove_vlan – Along with the vid_range <vidlist> parameter,
this command will remove VIDs to the previously configured STP
instance_id.
<vidlist> – Specify the VID range from configured VLANs set
on the Switch. Supported VIDs on the Switch range from ID
number 1 to 4094.
Only administrator-level users can issue this command.
DES-6500:4#config stp instance_id 2 add_vlan 10
Command : config stp instance_id 2 add_vlan 10
Success.
DES-6500:4#
81