D-Link TM DES-6500 Cli Manual page 228

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config access_profile profile_id (ipv6)
Restrictions
Example usage:
To configure a previously created access profile based on IPv6 classification:
DES-6500:4# config access_profile profile_id 4 add access_id 1 ipv6
class 1 flowlabel 0xABCD port 1:4 deny
Command: config access_profile profile_id 4 add access_id 1 ipv6
class 1 flowlabel 0xABCD port 1:4 deny
Success.
DES-6500:4#
delete access_profile
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete the access profile with a profile ID of 1:
used to determine the CoS queue to which packets are
forwarded to. Once this field is specified, packets accepted by
the Switch that match this priority are forwarded to the CoS
queue specified previously by the user.
{replace_priority} − Enter this parameter to re-write the 802.1p
•
default priority of a packet to the value entered in the Priority
field, which meets the criteria specified previously in this
command, before forwarding it on to the specified CoS queue.
Otherwise, a packet will have its incoming 802.1p user priority
re-written to its original value before being forwarded by the
Switch.
deny – Specifies that packets that match the access profile are not
permitted to be forwarded by the Switch and will be filtered.
delete access_id <value 1-65535> − Use this command to delete a
specific rule from the IPv6 profile. Up to 65535 rules may be
specified for the IPv6 access profile.
Only administrator-level users can issue this command.
Used to delete a previously created access profile.
delete access_profile profile_id <value 1-8>
The delete access_profile command is used to delete a
previously created access profile on the Switch.
profile_id <value 1-8> − Enter an integer between 1 and 8 that is
used to identify the access profile that will be deleted with this
command. This value is assigned to the access profile when it is
created with the create access_profile command.
Only administrator-level users can issue this command.
225