D-Link TM DES-6500 Cli Manual page 170

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config authen server_host
Restrictions
Example usage:
To configure a TACACS authentication server host, with port number 4321, a timeout value of 12 seconds and a
retransmit count of 4.
DES-6500:4#config authen server_host 10.1.1.121 protocol tacacs
port 4321 timeout 12 retransmit 4
Command: config authen server_host 10.1.1.121 protocol tacacs
port 4321 timeout 12 retransmit 4
Success.
DES-6500:4#
delete authen server_host
Purpose
Syntax
Description
Parameters
TACACS protocol.
xtacacs - Enter this parameter if the server host utilizes the
XTACACS protocol.
tacacs+ - Enter this parameter if the server host utilizes
the TACACS+ protocol.
radius - Enter this parameter if the server host utilizes the
RADIUS protocol.
port <int 1-65535> - Enter a number between 1 and 65535 to define
the virtual port number of the authentication protocol on a server
host. The default port number is 49 for
TACACS/XTACACS/TACACS+ servers but the user may set a
unique port number for higher security. The default port number for
RADIUS servers is 1812.
key <key_string 254> - Authentication key to be shared with a
configured TACACS+ server only. Specify an alphanumeric string
up to 254 characters or choose none.
timeout <int 1-255> - Enter the time in seconds the Switch will wait
for the server host to reply to an authentication request. The default
value is 5 seconds.
retransmit <int 1-255> - Enter the value in the retransmit field to
change how many times the device will resend an authentication
request when the TACACS, XTACACS or RADIUS server does not
respond. This field is inoperable for the TACACS+ protocol.
Only administrator-level users can issue this command.
Used to delete a user-defined authentication server host.
delete authen server_host <ipaddr> protocol [tacacs | xtacacs |
tacacs+ | radius]
This command is used to delete a user-defined authentication
server host previously created on the Switch.
server_host <ipaddr> - The IP address of the remote server host to
delete.
protocol – The protocol used by the server host to delete. The user
may choose one of the following:
167