D-Link TM DES-6500 Cli Manual page 70

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
create syslog host
Restrictions
Example usage:
To create syslog host:
DES-6500:4#create syslog host 1 severity all facility local0 ipaddress
10.53.13.94 state enabled
Command: create syslog host 1 severity all facility local0 ipaddress
10.53.13.94 state enabled
Success.
DES-6500:4#
config syslog host
Purpose
Syntax
Description
Parameters
where syslog messages will be sent.
state [enabled | disabled] − Allows the sending of syslog messages to
the remote host, specified above, to be enabled and disabled.
Only administrator-level users can issue this command.
Used to configure the syslog protocol to send system log data to a
remote host.
config syslog host <index 1-4> [severity [informational |
warning | all] | facility [local0 | local1 | local2 | local3 | local4 |
local5 | local6 | local7] | udp_port<udp_port_number> |
ipaddress <ipaddr> | state [enabled | disabled]]
The config syslog host command is used to configure the syslog
protocol to send system log information to a remote host.
<index 1-4> − Specifies that the command will be applied to an
index of hosts. There are four available indexes, numbered 1
through 4.
severity − Severity level indicator. These are described in the
following:
Bold font indicates that the corresponding severity level is
currently supported on the Switch.
Numerical Severity
Code
0 Emergency: system is unusable
1 Alert: action must be taken immediately
2 Critical: critical conditions
3 Error: error conditions
4 Warning: warning conditions
5 Notice: normal but significant condition
6 Informational: informational messages
7 Debug: debug-level messages
informational − Specifies that informational messages will be sent
to the remote host. This corresponds to number 6 from the list
above.
67