D-Link TM DES-6500 Cli Manual page 291

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config rip
Restrictions
Example Usage:
To change the RIP receive mode for the IP interface System:
DES-6500:4#config rip ipif System rx_mode v1_only
Command: config rip ipif System rx_mode v1_only
Success.
DES-6500:4#
enable rip
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To enable RIP:
DES-6500:4#enable rip
Command: enable rip
Success.
DES-6500:4#
disable rip
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
reception of RIP packets.
v1_only − Specifies that only RIP v1 packets will be
•
transmitted.
v2_only - Specifies that only RIP v2 packets will be
•
transmitted.
v1_or_v2 - Specifies that only RIP v1 or v2 packets will be
•
transmitted.
state [enabled | disabled] − Allows RIP to be enabled and
disabled on the Switch.
Only administrator-level users can issue this command.
Used to enable RIP.
enable rip
This command is used to enable RIP on the Switch.
None.
Only administrator-level users can issue this command.
Used to disable RIP.
disable rip
This command is used to disable RIP on the Switch.
None.
Only administrator-level users can issue this command.
288