D-Link TM DES-6500 Cli Manual page 173

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config authen server_group
Restrictions
Example usage:
To add an authentication host to server group "group_1":
DES-6500:4#config authen server_group group_1 add server_host
10.1.1.121 protocol tacacs+
Command: config authen server_group group_1 add server_host
10.1.1.121 protocol tacacs+
Success.
DES-6500:4#
built into the Switch (TACACS/XTACACS/TACACS+/RADIUS), or by
a user-defined group previously created using the create authen
server_group command.
tacacs – Use this parameter to utilize the built-in TACACS
server protocol on the Switch. Only server hosts utilizing
the TACACS protocol may be added to this group.
xtacacs – Use this parameter to utilize the built-in
XTACACS server protocol on the Switch. Only server hosts
utilizing the XTACACS protocol may be added to this group.
tacacs+ – Use this parameter to utilize the built-in
TACACS+ server protocol on the Switch. Only server hosts
utilizing the TACACS+ protocol may be added to this group.
radius - Use this parameter to utilize the built-in RADIUS
server protocol on the Switch. Only server hosts utilizing
the RADIUS protocol may be added to this group.
<string 15> - Enter an alphanumeric string of up to 15
characters to define the previously created server group.
This group may add any combination of server hosts to it,
regardless of protocol.
[add | delete] – Enter the correct parameter to add or delete a server
host from a server group.
server_host <ipaddr> - Enter the IP address of the previously
configured server host to add or delete.
protocol – Enter the protocol utilized by the server host. There are
four options:
tacacs – Use this parameter to define the protocol if the
server host is using the TACACS authentication protocol.
xtacacs – Use this parameter to define the protocol if the
server host is using the XTACACS authentication protocol.
tacacs+ – Use this parameter to define the protocol if the
server host is using the TACACS+ authentication protocol.
radius – Use this parameter to define the protocol if the
server host is using the RADIUS authentication protocol.
Only administrator-level users can issue this command.
170