D-Link TM DES-6500 Cli Manual page 118

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
Example usage:
To add the mirroring ports:
DES-6500:4# config mirror port 1:10 add source ports 1:1-1:5 both
Command: config mirror port 1:10 add source ports 1:1-1:5 both
Success.
DES-6500:4#
config mirror port delete
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete the mirroring ports:
DES-6500:4#config mirror port 1:10 delete source port 1:1-1:5 both
Command: config mirror 1:10 delete source port 1:1-1:5 both
Success.
DES-6500:4#
Used to delete a port mirroring configuration.
config mirror port <port> delete source port <portlist> [rx | tx
| both]
This command is used to delete a previously entered port
mirroring configuration.
port <port> − This specifies the Target port (the port where
mirrored packets will be sent). The port is specified by listing the
lowest slot number and the beginning port number on that slot,
separated by a colon. For example, 1:3 specifies slot number 1,
port 3. 2:4 specifies slot number 2, port 4.
delete source port – Adding this parameter will delete source ports
according to ports entered using the <portlist>.
<portlist> − This specifies a range of ports that will be mirrored.
That is, the range of ports in which all traffic will be copied and
sent to the Target port. The port list is specified by listing the
lowest slot number and the beginning port number on that slot,
separated by a colon. Then the highest slot number, and the
highest port number of the range (also separated by a colon) are
specified. The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies slot number 1,
port 3. 2:4 specifies slot number 2, port 4. 1:3-2:4 specifies all of
the ports between slot 1, port 3 and slot 2, port 4 − in numerical
order.
tx − Allows the mirroring of only packets sent to (flowing out of) the
port or ports in the port list.
both − Mirrors all the packets received or sent by the port or ports
in the port list.
Only administrator-level users can issue this command.
115