D-Link TM DES-6500 Cli Manual page 202

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config 802.1x auth_parameter
Restrictions
Example usage:
To configure 802.1x authentication parameters for ports 1 – 20 of switch 1:
DES-6500:4#config 802.1x auth_parameter ports 1:1 – 1:20 direction both
Command: config 802.1x auth_parameter ports 1:1 – 1:20 direction both
Success.
DES-6500:4#
config 802.1x auth_protocol
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the authentication protocol on the Switch:
DES-6500:4# config 802.1x auth_protocol local
Command: config 802.1x auth_protocol local
Success.
DES-6500:4#
sending packets to a supplicant (user).
reauth_period <sec 1-65535> − Configures the time interval
between successive re-authentications.
enable_reauth [enable | disable] − Determines whether or not the
Switch will re-authenticate. Enabled causes re-authentication of
users at the time interval specified in the Re-authentication Period
field, above.
Only administrator-level users can issue this command.
Used to configure the 802.1x authentication protocol on the
Switch.
config 802.1x auth_protocol [local | radius_eap]
The config 802.1x auth_protocol command enables you to
configure the authentication protocol.
[local | radius_eap] – Specify the type of authentication protocol
desired.
Only administrator-level users can issue this command.
199