D-Link TM DES-6500 Cli Manual page 278

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config route redistribute dst rip src
Parameters
Restrictions
Example Usage:
To configure route redistributions:
DES-6500:4#config route redistribute dst ospf src rip mettype
type_1 metric 2
Command: config route redistribute dst ospf src rip mettype
type_1 metric 2
Success.
DES-6500:4#
delete route redistribute
Purpose
Syntax
Description
Parameters
Restrictions
src {all | internal | external | type_1 | type_2 | inter+e1 | inter+e2} −
Allows the selection of the protocol of the source device. The user
may choose between:
all – Specifies both internal an external.
•
internal – Specifies the internal protocol of the source device.
•
external - Specifies the external protocol of the source
•
device.
type_1 - Calculates the metric (for RIP to OSPF) by adding
•
the destination's interface cost to the metric entered in the
Metric field.
type_2 - Uses the metric entered in the Metric field without
•
change. This field applies only when the destination field is
OSPF.
inter+e1 – Specifies the internal protocol AND type 1 of the
•
external protocol.
inter+e2 – Specifies the internal protocol AND type 2 of the
•
external protocol.
metric <value 0-16> − Allows the entry of an OSPF interface cost.
This is analogous to a Hop Count in the RIP routing protocol.
Only administrator-level users can issue this command.
Used to delete an existing route redistribute configuration on the
Switch.
delete route redistribute {dst [rip | ospf] src [rip | static | local
| ospf]}
This command will delete the route redistribution settings on this
switch.
dst [rip | ospf] − Allows the selection of the protocol on the
destination device. The user may choose between RIP and OSPF.
src [rip | static | local | ospf] − Allows the selection of the protocol
on the source device. The user may choose between RIP, static,
local or OSPF.
Only administrator-level users can issue this command.
275