D-Link TM DES-6500 Cli Manual page 32

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
Example usage:
To configure the port security:
DES-6500:4#config port_security ports 5:1-5:5 admin_state enabled
max_learning_addr 5 lock_address_mode DeleteOnReset
Command: config port_security ports 5:1-5:5 admin_state enabled
max_learning_addr 5 lock_address_mode DeleteOnReset
Success
DES-6500:4#
show port_security
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the port security configuration:
DES-6500:4#show port_security ports 1:1-1:10
Command: show port_security ports 1:1-1:10
Port# Admin State
----
1:1
1:2
1:3
1:4
1:5
1:6
1:7
1:8
1:9
1:10
DES-6500:4#
Used to display the current port security configuration.
show port_security {ports <portlist>}
This command is used to display port security information of the
Switch ports. The information displayed includes port security admin
state, maximum number of learning address and lock mode.
ports <portlist> − Specifies a range of ports to be displayed. The
port list is specified by listing the lowest slot number and the
beginning port number on that switch, separated by a colon. Then the
highest slot number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
slot number 1, port 3. 2:4 specifies slot number 2, port 4. 1:3-2:4
specifies all of the ports between slot 1, port 3 and slot 2, port 4 − in
numerical order.
None.
Max. Learning Addr.
----------- -------------------
Disabled 1
Disabled 1
Disabled 1
Disabled 1
Disabled 1
Disabled 1
Enabled 10
Disabled 1
Disabled 1
Disabled 1
Lock Address Mode
-----------------
DeleteOnReset
DeleteOnReset
DeleteOnReset
DeleteOnReset
DeleteOnReset
DeleteOnReset
DeleteOnReset
DeleteOnReset
DeleteOnReset
DeleteOnReset
29