D-Link TM DES-6500 Cli Manual page 231

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
create cpu access_profile
address mask.
destination_mac <macmask> - Specifies to examine the destination
•
MAC address mask.
ethernet_type − Specifies that the switch will examine the Ethernet
•
type value in each frame's header.
ip − Specifies that the switch will examine the IP address in each frame's
header.
vlan − Specifies a VLAN mask.
•
source_ip_mask <netmask> − Specifies an IP address mask for the
•
source IP address.
destination_ip_mask <netmask> − Specifies an IP address mask for
•
the destination IP address.
dscp − Specifies that the switch will examine the DiffServ Code
•
Point (DSCP) field in each frame's header.
icmp − Specifies that the switch will examine the Internet Control
•
Message Protocol (ICMP) field in each frame's header.
•
ICMP Type field.
•
ICMP Code field.
igmp − Specifies that the switch will examine each frame's Internet
•
Group Management Protocol (IGMP) field.
•
IGMP Type field.
tcp − Specifies that the switch will examine each frames Transport
•
Control Protocol (TCP) field.
•
the source port.
•
the destination port.
flag_mask [ all | {urg | ack | psh | rst | syn | fin}] – Enter the
•
appropriate flag_mask parameter. All incoming packets have TCP
port numbers contained in them as the forwarding criterion. These
numbers have flag bits associated with them which are parts of a
packet that determine what to do with the packet. The user may
deny packets by denying certain flag bits within the packets. The
user may choose between all, urg (urgent), ack
(acknowledgement), psh (push), rst (reset), syn (synchronize) and
fin (finish).
udp − Specifies that the switch will examine each frame's Universal
•
Datagram Protocol (UDP) field.
•
the source port.
type − Specifies that the switch will examine each frame's
code − Specifies that the switch will examine each frame's
type − Specifies that the switch will examine each frame's
src_port_mask <hex 0x0-0xffff> − Specifies a TCP port mask for
dst_port_mask <hex 0x0-0xffff> − Specifies a TCP port mask for
src_port_mask <hex 0x0-0xffff> − Specifies a UDP port mask for
228