D-Link TM DES-6500 Cli Manual page 203

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config 802.1x init
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To initialize the authentication state machine of some or all:
DES-6500:4# config 802.1x init port_based ports all
Command: config 802.1x init port_based ports all
Success.
DES-6500:4#
Used to initialize the 802.1x function on a range of ports.
config 802.1x init [port_based ports [<portlist>| all] |
mac_based [ports] [<portlist> | all] {mac_address <macaddr>]
The config 802.1x init command is used to immediately initialize
the 802.1x functions on a specified range of ports or for specified
MAC addresses operating from a specified range of ports.
port_based – This instructs the Switch to initialize 802.1x functions
based only on the port number. Ports approved for initialization
can then be specified.
ports <portlist> − Specifies a range of ports. The port list
is specified by listing the lowest slot number and the
beginning port number on that slot, separated by a colon.
Then the highest slot number, and the highest port number of
the range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a
dash. For example, 1:3 specifies slot number 1, port 3. 2:4
specifies slot number 2, port 4. 1:3-2:4 specifies all of the
ports between slot 1, port 3 and slot 2, port 4 − in numerical
order.
all − Specifies all of the ports on the Switch.
mac_based - This instructs the Switch to initialize 802.1x functions
based on the MAC address of a device on a specific port or range
of ports. MAC address approved for initialization can then be
specified.
ports <portlist> − Specifies a range of ports. The port list
is specified by listing the lowest slot number and the
beginning port number on that slot, separated by a colon.
Then the highest slot number, and the highest port number of
the range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a
dash. For example, 1:3 specifies slot number 1, port 3. 2:4
specifies slot number 2, port 4. 1:3-2:4 specifies all of the
ports between slot 1, port 3 and slot 2, port 4 − in numerical
order.
all − Specifies all of the ports on the Switch.
mac_address <macaddr> - Specifies the MAC address of the
client to be added.
Only administrator-level users can issue this command.
200