Enter/Exit Programming Mode
Configure actions (up to three) for the function keys
Configure Actions for F1
DEFAULT
$CPWEV
Configures Action for F1
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
Configure Actions for F2
DEFAULT
252
ACTION CONFIGURATION FOR FUNCTION KEYS
$CPWEV0000\r
F1 No Actions Configured
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
for the Function Key you want to program. Next scan
4 digits from the Alphanumeric characters in
dix D, Keypad
.
The first digit must be 0; the following 3 digits must
be configured according to the CMD_ID numbers in
Table 27 on page 251
ENTER/EXIT bar code again.
~
CANCEL
$CPWET0000\r
F2 No Actions Configured
PowerScan™ PD953X/PBT950X/PM950X
Appen-
. End by scanning the