Enter/Exit Programming Mode
Quantity/Code Send Mode
This feature defines the rules that will be used to send a QTY/CODE pair:
0. Code is transmitted with QTY field (and its predefined format) preceding
1. Code is transmitted with CODE field (and its predefined format) preceding QTY
2. Code in CODE field is sent out for the number of times defined in the QTY field
$CPWEH00\r
Qty precedes Code
$CPWEH02\r
Code transmitted Qty times
Quantity/Code Separator
This feature allows the insertion of a separator between Qty/Code pairs.
DEFAULT
$CPWQP
Set Qty/Code string separator
260
CODE field (and its predefined format)
field (and its predefined format)
DEFAULT
$CPWEH01\r
Code precedes Qty
$CPWQP00\r
No separator
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the barcode
at left. Next scan 1 digit from
(in the range 1-8) representing the number of charac-
ters to be used as separator.
Finally, define the separator string by reading the
desired characters from the ASCII table at the back of
this manual, expressed in hexadecimal form. End by
scanning the ENTER/EXIT bar code again.
PowerScan™ PD953X/PBT950X/PM950X
Appendix D, Keypad