RS-485 Master Header/Terminator ( Prefix/Suffix)
Specifies the Master Cradle header or terminator characters to be added to a
label sent to Host. The characters may be added as a prefix (in a position
before the bar code data, also called a header) and/or as a suffix (in a posi-
tion following the bar code data, also called a terminator).
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE bar
code above to place the unit in Programming Mode, then the "Set Master
Cradle Prefix" or "Set Master Cradle Suffix" bar code followed by the digits
(in hex) from the Alphanumeric characters in
senting your desired character(s). If less than the expected string of 8 char-
acters are selected, scan the ENTER/EXIT bar code to terminate the string.
Exit programming mode by scanning the ENTER/EXIT bar code again.
$CR4A1
Set Master Cradle Suffix
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
RS-485 Cradle Address
Specifies the Address for the Cradle in the RS-485 network..
$CS1AD
Set Cradle Address
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
Product Reference Guide
Enter/Exit Programming Mode
Appendix D, Keypad
$CR4A0
Set Master Cradle Prefix
~
CANCEL
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by the digits from the Alphanumeric
Appendix D, Keypad
characters in
your desired character(s). End by scanning the
ENTER/EXIT bar code again.
~
CANCEL
repre-
representing
241