Configure Actions For F1; Configure Actions For F2 - Datalogic PowerScan 9500 Series Product Reference Manual

Enter/Exit Programming Mode
Configure actions (up to three) for the function keys

Configure Actions for F1

DEFAULT
$CPWEV
Configures Action for F1
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.

Configure Actions for F2

DEFAULT
$CPWET
Configure Actions for F2
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
254
ACTION CONFIGURATION FOR FUNCTION KEYS
$CPWEV0000\r
F1 No Actions Configured
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code for
the Function Key you want to program. Next scan 4 dig-
its from the Alphanumeric characters in
Keypad.
The first digit must be 0; the following 3 digits must
be configured according to the CMD_ID numbers in
Table 27 on page 253
ENTER/EXIT bar code again.
~
CANCEL
$CPWET0000\r
F2 No Actions Configured
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code for
the Function Key you want to program. Next scan 4 dig-
its from the Alphanumeric characters in
Keypad.
The first digit must be 0; the following 3 digits must be
configured according to the CMD_ID numbers in
Table 27 on page 253. End by scanning the
ENTER/EXIT bar code again.
~
CANCEL
PowerScan™ PD9530/PBT9500/PM9500
Appendix D,
. End by scanning the
Appendix D,